IR heating hangar
IR heating hangar.
Heating hangars will always be the most expensive part of production. The reason is the size of these rooms, which have both grandiose areas and impressive ceiling heights. Existing types of heating by the principle of operation are reduced to two main methods - convective heating, in which air is heated and infrared heating, in which objects are heated.
If an industrial building (for example, a warehouse) has a ceiling height of about 3.5 meters, it can also be heated with air heating. All heating systems in this case will have similar operating costs for heating.
And, of course, in a convective way, you will not be able to heat certain areas of the room.
- Advantages of Hangar Heating with IR Heaters:
- Creation of different temperature zones
- Possibility of local heating of the required zone
- Efficient heat distribution
- Flexible temperature control
Depending on the task, we can offer several options for solving the heating of the hangar - full or local.
With full (autonomous) heating of the industrial premises, heaters are hung as evenly as possible on the ceiling. In the event that ceiling installation is not possible or difficult for some reason, industrial IR panels are installed on the walls, at the calculated angle, in the places of the greatest heat loss, to cover the maximum area of the room.
With local heating in the hangar of the selected zone, the Nth number of heaters is set above the required zone. Typically, the calculation is based on a power of 200W / m2. For best effect, heaters should be directed to the same point from different sides.
With infrared heating the hangar you do not need to stop your production. A highly qualified installation team of Teplov can install the necessary equipment at night.
You can also find other options for industrial heating.